We've reprogrammed the esc's on the ROV endlessly, and calibrated them endlessly, in our attempts to get it to fly correctly. While upgrading the software and firmware last night, we noticed something that is going to make flying it a lot easier. Often we've found that using the steering keys to send inputs to the esc's produces unpredictable results - sometimes the propeller will spin correctly, sometimes not at all, and sometimes will cut out unexpectedly. Last night we discovered that double-tapping the keys was effective 100% of the time, even after reboots and power loss.
So, it still flies like an underwater brick. But at least we can control our underwater brick predictably now. I'm calling this a victory.
Our next dive is coming up soon - heading to Barton Creek to find and video underwater wildlife in early May. We'll have some upgrades to roll out by then including a new cinching strap to keep the main tube sealed, and a 4000 lumen torch to increase our low-light capture with the GoPro. Exciting times for AustinROV.
We also upgraded the OpenROV software image which greatly improved the compass stability. Our IMU still thinks it is upside down though...
--DannyE can't comment without a G+ :(
Thursday, April 21, 2016
Saturday, April 16, 2016
When you fail so much it feels normal
We flew the ROV at the boat ramp at the iconic Loop 360 Bridge. This picture was before the rain.
During setup we discovered problems with the laptop. There would be no screencast recording for this dive. We're off to a rough start already.
Richard is installing our freshly charged and brand new batteries. They worked great! Runtime is a little over an hour per set of six batteries. (11,000mAh 3s LiPO)
This also happened.
Other highlights:
PS: LAZERS!!!
During setup we discovered problems with the laptop. There would be no screencast recording for this dive. We're off to a rough start already.
Richard is installing our freshly charged and brand new batteries. They worked great! Runtime is a little over an hour per set of six batteries. (11,000mAh 3s LiPO)
We saw a fish!
Lots of fish, actually.
The gopro once again didn't capture much, this time it was due to the low light conditions and murky water in Lake Austin. We need either a much better low-light camera or a much larger light source with the gopro.
This also happened.
Other highlights:
- vertical propeller slipping on the shaft stranded us at the bottom
- fishing line tied up the starboard propeller
- main tube flooded after desiccant swap (dirty o-rings?)
- reached maximum depth of 4.7 meters
PS: LAZERS!!!
Tuesday, April 5, 2016
Lou Neff Point - Best dive yet!
Two weeks ago we had our best dive to date! We took the ROV out to Lou Neff point to see what type of wildlife we could capture on the cameras. I'm happy to say the dive was almost a complete success!
Do you remember, from above, I said this dive was almost a complete success? With so many components on this ROV, we were bound to have some type of an issue. Sure enough, after 45 minutes of exploring Lou Neff point, and right in the middle of my piloting session, the ROV died. Once we reel it back in we notice that one of the batteries has completed died (I mean D.E.A.D.). It has been quite awhile since we bought new batteries, so losing one is not that hard to imagine.
Next steps:



![]() |
| We did't bring the correct seal, so this is Danny's attempt to fit a smaller one on the port battery tube. |
| Danny & Jim doing pre-dive checks. |
![]() |
| It's hard to complain with that view! |
| Jim searching for wildlife. |
| We captured a turtle! SUCCESS!! |
| Danny's expression explains how we all felt about this dive! |
Do you remember, from above, I said this dive was almost a complete success? With so many components on this ROV, we were bound to have some type of an issue. Sure enough, after 45 minutes of exploring Lou Neff point, and right in the middle of my piloting session, the ROV died. Once we reel it back in we notice that one of the batteries has completed died (I mean D.E.A.D.). It has been quite awhile since we bought new batteries, so losing one is not that hard to imagine.
Next steps:
- Buy new batteries
- Find the battery tube seal
- Continue this dive's success!
Sunday, October 4, 2015
For real this time
We took the ROV to the San Marcos River today at La Isla. This is sort of how it went, though it doesn't tell the whole story.
The reality is that for most of the time we could only see a blue abyss, even in bright daylight and clear water.
By the end we had collected some water inside the main tube and called it a day.
Steering was still a huge problem. The ROV always wants to go left. No matter what. We have swapped motors, propellers, tried inversion settings and updated the software to try and solve this problem to no avail. Our newly joined member Evan suggested we try a fixed-position rudder. We may just do it. I am willing to try almost anything given how bad this neutrally buoyant brick flies.
The reality is that for most of the time we could only see a blue abyss, even in bright daylight and clear water.
By the end we had collected some water inside the main tube and called it a day.
Steering was still a huge problem. The ROV always wants to go left. No matter what. We have swapped motors, propellers, tried inversion settings and updated the software to try and solve this problem to no avail. Our newly joined member Evan suggested we try a fixed-position rudder. We may just do it. I am willing to try almost anything given how bad this neutrally buoyant brick flies.
San Marvelous
Road Trip! DannyE drove us down to San Marcos, TX to test the ROV out in the crystal clear water of the San Marcos River on Sunday. It went surprisingly well, as far as things for the ROV project are concerned. First of all, the day was gorgeous:
We set up shop on an island in the middle of the river, by Rio Vista park. The island is accessed by a small concrete bridge - carrying a bunch of electronics across that bridge was fun stuff. The ROV may be waterproof, but most of our gear certainly isn't.
In any case, after setting up and and clearing our pre-dive checks, we chose to launch from this choice looking spot:
The goal was to dive in the still area between the fast flowing water on the southern side of the island and the slower (yet still powerful, compared to the ROV's motors) current on the northern side.
And dive we did!
Safe to say the San Marcos River was far more powerful than our little robot. We explored the immediate environs but were swept away by the current repeatedly. However, we seemed to draw quite a few curious onlookers, including human, piscine, and testudine ones.
Oh, and we saw a really special creature breach the water at one point:
We took a lot of video both from the ROV and the GoPro attached to it. We'll be editing video and throwing it up here soon so that everyone can see what we're seeing while the ROV is underwater. We think you'll like it.
We are also really looking forward to diving in some calmer waters more suited to the ROV's power level - namely, lakes like Lake Buchanan. We are in the planning stages of an exhibition there soon, to look for remnants of the lost city of Bluffton. Whether we find it or not, we're finally able to use the ROV out in the real world and it feels pretty darn good. More to come, soon!
![]() |
| The dive staging area |
We set up shop on an island in the middle of the river, by Rio Vista park. The island is accessed by a small concrete bridge - carrying a bunch of electronics across that bridge was fun stuff. The ROV may be waterproof, but most of our gear certainly isn't.
In any case, after setting up and and clearing our pre-dive checks, we chose to launch from this choice looking spot:
![]() |
| Our launching point - a tiny pier and some beautiful water |
The goal was to dive in the still area between the fast flowing water on the southern side of the island and the slower (yet still powerful, compared to the ROV's motors) current on the northern side.
And dive we did!
![]() |
| Thar she blows! |
Safe to say the San Marcos River was far more powerful than our little robot. We explored the immediate environs but were swept away by the current repeatedly. However, we seemed to draw quite a few curious onlookers, including human, piscine, and testudine ones.
Oh, and we saw a really special creature breach the water at one point:
Oh hi
We are also really looking forward to diving in some calmer waters more suited to the ROV's power level - namely, lakes like Lake Buchanan. We are in the planning stages of an exhibition there soon, to look for remnants of the lost city of Bluffton. Whether we find it or not, we're finally able to use the ROV out in the real world and it feels pretty darn good. More to come, soon!
Wednesday, September 23, 2015
AustinROV
Welcome back! We have updated the blog name to reflect the new mission of the group. Just because we've moved on from our original goal of exploring Jacob's Well, our focus on doing citizen science and exploring with the OpenROV project is still alive and well. We're exploring a lot of interesting possibilities for underwater dives in the Austin area, including underwater ghost towns in the Highland Lakes chain, and are excited to start planning some of these expeditions out. We plan to continue blogging about both the technology challenges we encounter with the OpenROV platform as well as detailing any finds we make along the way. Thanks so much for reading the blog so far and we hope you continue to follow us on our underwater journeys.
Monday, September 14, 2015
Three good tests
The OpenROV team says "you can build it in a weekend" but to us the reality was much closer to 18 months. I think this is an example of how "dreamy" the OpenROV folks are. They have very lofty ideas but execution always leaves something to be desired.
A short example, the next version up from 2.5.1 is version 30.0.0. Maybe they fudged the version number, something that could be corrected, but they went ahead with it. It isn't all that revolutionary or a silver bullet for the 2.5.1 problems, just an incremental change.
Ah, the perils of being an early backer of an open source project. The upside is that things improve all the time, like software. The downside is that as things improve, you are stuck with the "old world" hardware and software you started with. We bought LiPo batteries for our 2.6 kit, and very soon after we found that there was no way to use them, the OpenROV team switched to a new LiFePo battery type requiring all new ROV geometry and chargers. We decided to stick with LiPo and went with a much higher current 26650 battery.
Finally, we are ready to actually dive our project OpenROV. It doesn't fly perfectly but we think it is about as good as it can get with this platform. We've fought software, firmware, hardware and collaboration issues to get here. Now that we're ready, the place we thought we were going seems to have slipped further out of reach.
Sadly we probably won't be going to Jacob's Well. This is partly because we can't rely on the ROV being able to get back out of the well and the JWEP makes our efforts redundant. It is also worth mention that we couldn't get ahold of anyone at JWNA or Wimberly Valley Watershed to even discuss our project.
A short example, the next version up from 2.5.1 is version 30.0.0. Maybe they fudged the version number, something that could be corrected, but they went ahead with it. It isn't all that revolutionary or a silver bullet for the 2.5.1 problems, just an incremental change.
Ah, the perils of being an early backer of an open source project. The upside is that things improve all the time, like software. The downside is that as things improve, you are stuck with the "old world" hardware and software you started with. We bought LiPo batteries for our 2.6 kit, and very soon after we found that there was no way to use them, the OpenROV team switched to a new LiFePo battery type requiring all new ROV geometry and chargers. We decided to stick with LiPo and went with a much higher current 26650 battery.
Finally, we are ready to actually dive our project OpenROV. It doesn't fly perfectly but we think it is about as good as it can get with this platform. We've fought software, firmware, hardware and collaboration issues to get here. Now that we're ready, the place we thought we were going seems to have slipped further out of reach.
Sadly we probably won't be going to Jacob's Well. This is partly because we can't rely on the ROV being able to get back out of the well and the JWEP makes our efforts redundant. It is also worth mention that we couldn't get ahold of anyone at JWNA or Wimberly Valley Watershed to even discuss our project.
Subscribe to:
Posts (Atom)
















